Jump to content

Owl182

Members
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Hi, Ok, so i start the laptop, turn on the laser's key and then the laser, the pc recognises the laser with no problem BUT when i run EZ Cad2 there is a problem, the software "agreement" page opens but then when i click "ok" it disappears like normal but does not come back, after waiting a few minutes i try again but the software says "software is open" (which it isn't...) so now i cannot use the laser, i have uninstalled the driver and reinstalled, no difference, it does this with versions 09,10 and 11 of the software... Oh yes, if i unplug the laser usb cable then the software goes straight to demo mode, even a clean shutdown in demo does the same thing...
×
×
  • Create New...