Jump to content
  • 0
Sign in to follow this  
Ken

laser mark station Marking is uneven

Question

3 answers to this question

Recommended Posts

  • 0

Check and make sure your target is flat. Next be aware that leaving heat in an area for too long will cause it to curl like a patato chip, these are ususally just differetn shades of grey, if your unit is not tracking correctly you may be looking for another unit?

Share this post


Link to post
Share on other sites
  • 0

Grab a business card which is 86x54mm or something else with a known exact size then draw a box in excad that same size. Focus it the Light it and see if the light size is different than the card or or object you used. If it’s different you need to use a correction file provided by manufacturer. This is added to correction box in F3 parameters. It’s a huge pain doing it without this file. 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Answer this question...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...