Jump to content
  • 0
Sign in to follow this  
ctrl-c

driver card EZCad Configuraiton lost - simulation OK, but no engraving

Question

Hi,

I'm fairly new to EzCAD. Today a colleague of mine reboot the pc controling the laser, leading to a lost of all the configuration, which I found very odd. Anyway, I reconfigured everything based on a doc I found at the office, now the laser simulates the process, but stop right after.

What am I missing?

Thanks for your help

F

Share this post


Link to post
Share on other sites

1 answer to this question

Recommended Posts

  • 0

If you have lost your  machine settings you will need to manually setup your machine. We offer a free download to the latest EZCAD driver and software. They can be found on the download page. I will detail the minimum amount of steps needed to get the machine working again. If you share you operators manual and datasheets. We can provide more details specific to your machine.

After launching EZCAD software press "f3" it will launch the configuration tab. Select "LASER CONTROL" tab

Enter your laser type, "CO2, YAG, FIBER, SPI". You will also need to modify the "PWM". If you selected the fiber type select the serial communication most common is "IPG"

Capture2.PNG

Next we need to configure the galvanometer marking area by default the "Field Size" This is bare minimum amount of settings to get your laser working again. 

Capture3.PNG

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Answer this question...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...